poptop94 1 Report post Posted April 17, 2013 So I just started leveling my prot pally. My problem is when I switch seals threat plates switch modes as well. I have gone thru the settings but haven't found anything that seems to help. Anyone have any ideas? Thnx in advance. Quote Share this post Link to post Share on other sites
Vladamyr 169 Report post Posted April 17, 2013 Never seen this issue before and I couldn't find anyone else on google with this problem. It should only be switching when you change specs. Maybe a reinstall of the addon? Sorry that's not very helpful. Quote Share this post Link to post Share on other sites
Krazyito 521 Report post Posted April 17, 2013 I haven't used threat plates in quite a while, but i remember there being an option somewhere about when I switched forms as a druid (cat/bear) it I'd what your mentioning. I'll try to remember to install it later when I get home and try to find it. Quote Share this post Link to post Share on other sites
poptop94 1 Report post Posted April 17, 2013 (edited) Thanks for the replies. I hadn't thought of reinstalling, may give that a go later. Already jumped in the queue on my DK so it will have to wait a bit. Looking at the options on him however, there is a tab for presences. I don't recall seeing a similar tab for Seals but I may be mistaken. Again will check after queue pops. Will update this post accordingly. Ok I got it fixed. In the threat plates config there is an Auras tab. The only option in this tab is for Heart of the Crusader. Disabled this and now whatever seal I had up threat showed properly. I didn't turn off RF to see if that would flip the plates. Edited April 19, 2013 by poptop94 1 Quote Share this post Link to post Share on other sites
